Relax!

You didn't say what ADSM server you have, but for UNIX or NT, cd to the
directory where the server code is installed.  Stop the server and then from
the command prompt type dsmserv.  This will start the server in the
foreground.  After the server comes up, you will have an adsm> prompt and
can undo what you did.  I would probably set the password for your account,
start up a dsmadmc session and make sure you can connect.  Then change all
the passwords, or set authentication back off.

Kelly J. Lipp
Storage Solutions Specialists, Inc.
PO Box 51313
Colorado Springs CO 80949
719-531-5926
www.storsol.com
lipp AT storsol DOT com