Is there anyone who has experience running
tape reclamation with a single drive unit ?

I've set up the system so that that volumes(tapes) are
reclaimed to a reclamation pool which i've created on a harddisk.
This reclamation pool has a nextstoragepool which is my tape device.

When i start the reclamationprocess by lowering the reclamaition threshold
a tape volume is loaded into the drive, and data is moved to my reclamation
 pool.
When this pool reaches its max threshold it want to migrate data to a new
volume, but
the drive is occupied by a tape.

Question is , how can I tell ADSM to unload the drive, migrate the  data
from reclamation pool
to main storege pool, and then continue again reclaiming .


Hope this is clear and somebody can give me an answer.







        \|||/
        (. .)
+---oOOo-(_)-oOOo-------------------------------+
|
|              Hr R.J. van Doggenaar
|_______________Farnest Engineering B.V.___
|              POSTBUS 4315
|              2003 EH HAARLEM
|              TEL: 023-5338250
|_______________FAX:     023-5354063________________
|
|          E-MAIL: rj.van.doggenaar AT fcs DOT nl
|    oooO
|    (  )      Oooo
+-----\ (------(   )----------------------------+
       \_)      ) /
               (_/