tape status set to FULL but not at 100%

[henrychen]

Hi,



I have a few volumes of tape that have a status of FULL even though they are not at 100% capacity (LTO v1 tapes, some filled at 77%). I don't see a command to change the status of this tape to FILLING ... is my only option to to "move data" out of that volume to another stgpool and reclaim that volume?



Thanks.



-Henry

 

[heada]

Henry,



The tape was full at one point in time. Since then, data has expired from the tape, making it less then 100% used, but still full. You can either perform a move data on it, or reclaim it. (set your reclamation threshold to less then the % used on the tape)



-Aaron