Hello,
I need an expert advice. I label a new tapes to the pool and was used two days ago. Now, the tapes has only 24 % data utilize so I moved the data to another tape since the other tape has 60 % data. After the move finishes this is the result I get.
LIBRARY_NAME STATUS VOLUME LAST_USE
3583_LTO_1 Private L00877 Data
LIBRARY VOLUME EST_CAPACITY_MB %_util STATUS Stg Pool
3583_LTO_1 L00877 0.0 0.0 EMPTY 3583_lto_1
Also, an error ANR2411E:
ANR2411E Command: Unable to access associated volume volume name - access
mode is set to "unavailable".
Explanation: The command shown would require access to the volume whose name
is displayed (because data from the volume specified in the command spans
into this volume); the volume shown cannot be accessed because its status is
unavailable.
System Action: The server does not process the command.
User Response: If necessary, reset the status of the volume and reissue the
command.
The status was never "unavailable" and I even reset it again.
A feedback would be nice.
Thanks
I need an expert advice. I label a new tapes to the pool and was used two days ago. Now, the tapes has only 24 % data utilize so I moved the data to another tape since the other tape has 60 % data. After the move finishes this is the result I get.
LIBRARY_NAME STATUS VOLUME LAST_USE
3583_LTO_1 Private L00877 Data
LIBRARY VOLUME EST_CAPACITY_MB %_util STATUS Stg Pool
3583_LTO_1 L00877 0.0 0.0 EMPTY 3583_lto_1
Also, an error ANR2411E:
ANR2411E Command: Unable to access associated volume volume name - access
mode is set to "unavailable".
Explanation: The command shown would require access to the volume whose name
is displayed (because data from the volume specified in the command spans
into this volume); the volume shown cannot be accessed because its status is
unavailable.
System Action: The server does not process the command.
User Response: If necessary, reset the status of the volume and reissue the
command.
The status was never "unavailable" and I even reset it again.
A feedback would be nice.
Thanks