All,
I started getting error code 201, “unable to open
robotic path.” I am unable to inventory the robot or run
diagnostics, and I haven’t been able to execute my policies. As far
as I can tell, everything is configured correctly within NBU. I replaced
the SCSI cable and I have run the “configure robot” portion of the
wizard, as a safe measure. I used the driver included with the NBU
software to connect my Quantum Superloader3 and it was working fine. This error
started popping up out of the blue a few days ago and I have been unable to resolve
it.
Also, I downloaded and installed the Linux client. Do
you need xinetd installed/running for the Linux NBU client and NBU master to
see each other?