Re: [Veritas-bu] Robotic Path error
2009-03-30 09:54:59
On Mon, 30 Mar 2009, McDonald II, James F. wrote:
> All,
>
>
>
> I started getting error code 201, "unable to open robotic path." I am
> unable to inventory the robot or run diagnostics, and I haven't been
> able to execute my policies. As far as I can tell, everything is
> configured correctly within NBU. I replaced the SCSI cable and I have
> run the "configure robot" portion of the wizard, as a safe measure. I
> used the driver included with the NBU software to connect my Quantum
> Superloader3 and it was working fine. This error started popping up out
> of the blue a few days ago and I have been unable to resolve it.
>
>
>
> Also, I downloaded and installed the Linux client. Do you need xinetd
> installed/running for the Linux NBU client and NBU master to see each
> other?
>
>
If you run robtest locally on the robotic controller host, can you type "s
d" or "s s" to see the tape drives and tapes respectively?
Justin.
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|