Kelly,
We turned off NOM and that seemed to clear
it up back then. The rest of the thread form May including Ken Zufall who had
suggested NOM was the issue. I guess I forgot to post that it cleared the
problem for us.
From: Jeff Lightner
Sent: Thursday, May 01, 2008 10:04
AM
To: ken_zufall AT goodyear DOT com
Subject: RE: [Veritas-bu] Can't
access policies from Java GUI
Thanks.
I’d seen a technote at Symantec
about similar message not related to Policies though and it noted that NOM
could be an issue for that problem.
We did just turn on NOM yesterday so
we’ll try turning it off to see if it helps.
From: ken_zufall AT goodyear DOT com
[mailto:ken_zufall AT goodyear DOT com]
Sent: Thursday, May 01, 2008 9:57
AM
To: Jeff Lightner
Subject: Re: [Veritas-bu] Can't
access policies from Java GUI
Jeff,
We saw
the same thing when we went from 5.1 to 6.5. However, our issue isn't
likely to be the same as yours--we have since discovered that our master server
just isn't beefy enough now. We installed NOM and its constant calls for
information (policies, media, etc) totally slammed the master. We haven't
seen the problem since we turned NOM off.
Hope
that helps,
Ken
Zufall
Technical Analyst
D660C
The Goodyear Tire & Rubber Company
GTN 446.0592 or 330.796.0592
From: Kelly B Harris
[mailto:kbharris AT uab DOT edu]
Sent: Monday, October 06, 2008
4:11 PM
To: Jeff Lightner;
veritas-bu AT mailman.eng.auburn DOT edu
Subject: RE: [Veritas-bu] Can't
access policies from Java GUI
Has anyone
experience this? We are after upgrading from 6.0MP to 6.5.1.
Kelly Harris
University Of Alabama Birmingham
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Jeff Lightner
Sent: Thursday, May 01, 2008 8:40
AM
To:
veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Can't access
policies from Java GUI
We
upgraded from 6.0 MP4 to 6.5 earlier this week.
This
morning I’m attempting to view a policy from the Java GUI.
This is timing out and telling me that it can’t connect to the master
server and says to check to be sure necessary daemons are running.
It doesn’t say WHICH daemon unfortunately.
It
does eventually show me the policy but any time I click on things within it I
seem to be getting the same error or timeout.
Running
bpps –a from command line on master
shows
me many processes including the daemons I’m used to
seeing.
Activity
Monitor in the Java GUI has no issues.
Backups
are running and I was able to kick off a restore so I don’t want to just
stop/start NetBackup. Everything seems operational except this.
bpplinfo
from command line on master shows policy information without an issue.
Can
someone tell me which specific daemon would be involved here?
Is
there some security setting in 6.5 required to allow me to view policies that
wasn’t there in 6.0 that might be causing this issue?
----------------------------------
CONFIDENTIALITY NOTICE: This e-mail may contain privileged or confidential
information and is for the sole use of the intended recipient(s). If you are
not the intended recipient, any disclosure, copying, distribution, or use of
the contents of this information is prohibited and may be unlawful. If you have
received this electronic transmission in error, please reply immediately to the
sender that you have received the message in error, and delete it. Thank you.
----------------------------------