[Veritas-bu] 6.5.2 Windows GUI Bug - UP/DOWN Drives?
2008-06-19 17:12:40
I've
only got one 6.5.2 config and its a master/media combo on Windows 2003 with
two LTO3 drives shared via SSO. When I select the second drive to up or
down it, the gui only reconfigures the first drive. So for example this
afternoon I had to reboot the library. Both drives went into a down state
on the gui. Selecting the picture of drive 001 brought up a
notification box to up the paths to drive 000. If I go ahead and up these
paths, drive 000 goes up and drive 001 stays down. The only way that I can
figure out to up (or down) drive 001 is to use vmoprcmd. I opened a
ticket on this last time it happened and the support engineer said he wasn't
aware of a bug. I was a bit busy at the time so I didn't pursue it
further. Today it happened again. My plan is to upgrade another
environment next week to 6.5.2 so I can check on that environment, but is this
happening to anyone else? The GUI still doesn't refresh so you'll have to
Refresh All or use vmoprcmd to check.
-Jonathan
PS:
I'm sure this is part of an evil and subtle Symantec plot to make us all use the
command line by making the GUI
unusable. =P
|
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|