We had this exact same issue last year and have worked painfully with
Veritas for many months to get this problem resolved.

I can say, that after more than 12 months as a critical issue within
Veritas, that we are no closer to a fix than you are right now.  However, as
a work around, we found that replacing the file list directive
ALL_LOCAL_DRIVES with / will cause the backups to get more than just the C:
or D: identifier and actually back up files and directories on the disks.

This all comes down to OTM and how it returns drive information during the
start of a backup.  Another work around would be disabling OTM.

Hope this helps,

Rob Thelen
Storage Management
First USA Bank.

-----Original Message-----
From: bob.bakh AT cox DOT net [mailto:bob.bakh AT cox DOT net]
Sent: Thursday, June 27, 2002 2:28 PM
To: Karunanidhi Subramanian; Veritas-bu AT mailman.eng.auburn DOT edu
Subject: Re: [Veritas-bu] No Data Backed up. But exit code 0 !


This message uses a character set that is not supported by the Internet
Service.  To view the original message content,  open the attached message.
If the text doesn't display correctly, save the attachment to disk, and then
open it using a viewer that can display the original character set. 


**********************************************************************
This transmission may contain information that is privileged, confidential 
and/or exempt from disclosure under applicable law. If you are not the intended 
recipient, you are hereby notified that any disclosure, copying, distribution, 
or use of the information contained herein (including any reliance thereon) is 
STRICTLY PROHIBITED. If you received this transmission in error, please 
immediately contact the sender and destroy the material in its entirety, 
whether in electronic or hard copy format. Thank you
**********************************************************************