Hi, 

    We have a Sun E450 running Solaris 2.6 that is fibre connected to some
Brocade switches and bridged to DLT7000's.  We cleared out the dev/rmt
directory as well as the dev/sg directory, then did a reconfigure boot.
During boot, all DLT's are found and configured and dev/rmt as well as
dev/sg are pupoulated with the appropriate files.  However, when we try to
do an mt status on each drive, we get "no such device or address" error.
Also, when we run sgscan, all tapes and the changer are reported but they
are all reported on the same controller number even though 5 of the tapes
are on one fibre controller, 5 on another and the robot is on a SCSI
controller.  I don't think this is an issue specific to NBU, but I'm hoping
(for my sake, not yours ;-) ) that somebody may have run into something
similar to this.

Thanks for any help,
-mike andres