Re: [Networker] Setup Networker for DR test
2010-04-21 08:47:39
correct
EDWARD COTY
LEAD STORAGE ENGINEER, LCNA, NACP
WORK - 973-533-2098
CELL - 973-296-0918
EDWARD.COTY AT AIG DOT COM
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of grahambird80
Sent: Wednesday, April 21, 2010 4:08 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Setup Networker for DR test
Hello
Just to check
> so after mmrecov has loaded all the old server's config (including the tape
> library config that will not work correctly with whatever you have connected
> to the new system), then the next step is to remove the library config and
> replace it with a fresh config that will work for the library that's in
> place.
I take it you mean deleting the Libary system / Tape drive that show up in the
GUI and then adding the connected one?
+----------------------------------------------------------------------
|This was sent by graham.bird AT centrica DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|