Per a question I asked a few weeks ago (been OOO), will performing
"touch /reconfigure" & rebooting a Solaris Legato server break any
otherwise working Legato drive/jukebox configurations? I just want
to clean up from the one removed jukebox, not the other.
Sanity check before I perform this action.
Regards,
- michael
Lee Hanel wrote:
did you force a reconfigure and reboot after removing the jukebox? If
not, I believe that solaris still shows the devices. to do this, just
"touch /reconfigure" and then reboot your server as you normally would.
[snip]
On Fri, 2006-05-05 at 12:42 -0700, Michael Coxe wrote:
Hello folks,
/etc/LGTOuscsi/inquire returns information about a SCSI
jukebox that has been removed from our server.
system: Solaris 5.7, Networker 6.1.4
This stuff no longer attached:
----------
[email protected]:SONY SDX-500C 01 |Tape
[email protected]:SONY SDX-500C 01 |Tape, /dev/rmt/5cbn
[email protected]:SPECTRA 215 1010|Autochanger (Jukebox)
Any suggestions on how to make this go away?
I want to attached another device on this SCSI bus.
I tried an "/etc/LGTOuscsi/lreset 2" but no luck.
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
