[Networker] Groups and schedules missing following install?
2006-03-21 18:06:56
Hi,
I just installed 7.2.1 on a new Solaris 9 box and recovered the
bootstrap from our old Solaris server (runs NetWorker 6.1.1) using
mmrecov. Everything appeared to run OK, but I don't see any of our
groups or schedules when I launch nwadmin from the new server. However,
I do see all our volumes, and everything under the 'Save sets' window
looks valid, showing all our clients, etc.
I do see the following older files under /nsr/res (I assume from the
mmrecov):
servers
nsrla.res
nsrjb.res
nsr.res
and these newer ones from the initial install:
nsrwizclnt.res
.nsr
nsrdb/
I can grep for our groups and schedule names, so I know they're in these
older res files. Why do they not show up? How do I get them to?
Also, it's my understanding that the client indexes are not brought back
via mmrecov, so I will either have to copy them over from the old
server, or recover them from tape. Will they show up in the client
listing at that point?
I should note that the bootstrap on the older server was saved to a file
type device and recovered the same way on the new server because we
don't have a tape device or library on the new server, and we're
planning to use only a storage node. The new server was given the same
host and IP address as the old server, and the old server was
temporarily shut down before installing the software on the new box in
order to avoid IP conflicts. We only run backups at night, so we'll be
playing around with the new server during the day and then shutting it
down and then bringing up the old server to run our backups in the
evening. The old server will be permanently shut down once we have
finished all out testing and setup on the new box.
Any help would be greatly appreciated.
George
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Groups and schedules missing following install?,
George Sinclair <=
|
|
|