Folks,

We had a total failure of a RAID array on our main server.  After it took
the IBM tech's 2 days to get the hardware fixed we've started a restore and
it's going a lot slower than we'd like (it'll take 2 or 3 days to restore at
the present rate).  I wondered it anyone out there would have any
suggestions for speeding up the process.  At this point though I'm reluctant
to stop the restore we've got going unless I'm pretty sure I can improve the
speed enough to make a difference.

Our systems are as follows:

Backup Server:  Windows 2K, Legato 6.1.3 (I know I need to upgrade, it'll
happen in the next 3 months), Spectralogic 10K tape library with 2 AIT-2
tape drives, 100M network connection.

Server being restored:  Windows 2K, Legato 6.1.3, RAID array with 3 logical
drives (E:, F:, G:), 100M networking.  The system disk was ok.

We have about 250GB to restore and it appears to be going at about 2GB/hour
at this point.

To restore the drives we just opened Networker User on the restore system,
clicked on the 3 drives and told it to start.

I could give more information but it's probably better to answer any
specific questions you may have.

We will be upgrading to AIT-4 tapes and Networker 7.x before too long but
that doesn't do us any good now :-(

Any suggestions you may have would be appreciated.  It's probably too late
for this restore but could be useful for future reference.

Thanks, Dave

David Werth
Garmin AT, Inc
Salem, Oregon
dave.werth AT garmin DOT com



            ------------------------- 
This e-mail and any attachments may contain confidential material for the sole 
use of the intended recipient.  If you are not the intended recipient, please 
be aware that any disclosure, copying, distribution or use of this e-mail or 
any attachment is prohibited.  If you have received this e-mail in error, 
please contact the sender and delete all copies. 
Thank you for your cooperation 

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=