.login profile for which user? If you have to set the environment variable
it would be better to set it in /etc/init.d/networker (or wherever you
have the networker startup file)



Sincerely,

Arun Sondhi
CCNP,CCDP

Ph: +1 414.382.0206
Extn: 20206




Dave Martini 1 <martini AT MRPEABODY.LLNL DOT GOV>
Sent by: Legato NetWorker discussion <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>
12/09/2003 01:50 PM
Please respond to Legato NetWorker discussion; Please respond to Dave
Martini 1


        To:     NETWORKER AT LISTMAIL.TEMPLE DOT EDU
        cc:
        Subject:        [Networker] Tape Positioning by Record is Disabled on 
AIT Drives??????


I have Networker Server 7.1 and a Spectra Logic treefrog
with dual Sony AIT-3 Drives running on a solaris 9 server.

My st.conf entry looks like this

tape-config-list=
           "SONY SDX-700C", "SONY 8mm AIT-3 ", "SONY_AIT3";
            SONY_AIT3=1,0x36,0,0xd679,1,0x00,0;

Legato says that the syntax of my st.conf is correct for the Sony AIT-3.

But whenever I try to restore I get this error.

"Cannot decode block. Verify the device configuration. Tape positioning by
record is disabled."

Sometimes the recover works and sometimes the recover fails.

I called Legato and they said put these two environment variables in place
so I put them in the .login file on the UNIX solaris 9 legato server
machine and rebooted

setenv NSR_DEV_BLOCK_SIZE_AIT_3 192
setenv NSR_DEV_TAPE_FILE_SIZE 10922

The problem is still occuring.
Anyone run into this or have similar drives?
The integrity of these backups and the recovery process
is in question.

Dave Martini
LLNL

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=



--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=