This field is not the number of backup sessions per jukebox. It is the number 
of commands the jukebox can run at the
same time.

DO NOT change this from default install unless you are absolutely sure of the 
change. I have two clients that did this
causing jukebox load/unload problems due to too many commands running.

The defaults seem to be "1" for the jukeboxes I have seen , but there have been 
suggestions on this list that you can set
it to the number of drives in the jukebox.

Kit





On 10 Aug 2002 at 15:31, Martin J. Dellwo wrote:

> Does anyone know the appropriate 'max perallelism' setting for an ATD
> M1500 (20-slot) jukebox?  How about for an Overland Powerloader
> (9-slot)?  We are using both types, each contains two SDLT drives.
> --
> Martin J. Dellwo   (610) 458-5264 x6512   dellwo AT 3dp DOT com
> Systems Administrator, 3-Dimensional Pharmaceuticals, Inc.
> http://www.3dp.com/
>
> --
> Note: To sign off this list, send a "signoff" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
>http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>



++++++++++++++++++++++++++++++++++++++++++++++++
Kit Cunningham - idata Limited
Mobile  +64 21 448 444   email: k.cunningham AT idata.co DOT nz
Support Calls to:  0800 backup -         0800 222 587
Support email: support AT idata.co DOT nz
http://www.idata.co.nz
++++++++++++++++++++++++++++++++++++++++++++++++

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=