Im past versions setting the read only attribute resulted many tape 
notifications asking to mount another tape because
networker thought the read only drive could be used for backup.

Has this been cured??
Kit




On 11 Aug 2002 at 8:23, Byron Servies wrote:

> On August 11, 2002 at 11:36, Faidherbe, Thierry wrote:
> > The default is "Amount of drive -1". The goal is to keep 1 drive
> > inactive for recover purposes.
>
> In that case, set the read only attribute of the drive to true.
> The drive will only be available for recovers.
>
> Byron
>
> --
> Note: To sign off this list, send a "signoff" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>



++++++++++++++++++++++++++++++++++++++++++++++++
Kit Cunningham - idata Limited
Mobile  +64 21 448 444   email: k.cunningham AT idata.co DOT nz
Support Calls to:  0800 backup -         0800 222 587
Support email: support AT idata.co DOT nz
http://www.idata.co.nz
++++++++++++++++++++++++++++++++++++++++++++++++

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=