Re: Running dsmcad to show information from secondary tsm nodename
2006-01-19 12:16:12
Pete
By default dsmcad is listining with port 1581 , on your alternate nodename opt
file you can put the entry:
HTTPORT 1582
Load your dsmcad -optfile=......./alternate_nodename_optfile
And to connect to this alternate nodename : http://ipnumber:1582
Regards Robert Ouzen
Haifa University
Israel
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Peter Hitchman
Sent: ה 19 ינואר 2006 18:55
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Running dsmcad to show information from secondary tsm nodename
Hi,
To enable backups of Oracle 7 datafiles and to separate these out from the
normal backups I registered the machine again using a different nodename. Is it
possible to run the dsmcad programme in such a way that it will accept
connections to the machine and show the files that have been backed up on that
machine using the alternative nodename?
Regards
Pete
|
|
|