Andy,
that was it. I had badly setup my locale environment variable (LANG).

Thanx and best regards

Ing. Jozef Zatko
Login a.s.
Dlha 2, Stupava
tel.: (421) (2) 60252618



Andrew Raibeck <storman AT US.IBM DOT COM>
Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
12/01/2004 02:20 PM

Please respond to
"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>


To
ADSM-L AT VM.MARIST DOT EDU
cc

Subject
Re: Admin command line problem






The admin CLI -DATAONLY option is platform neutral. Thus it doesn't matter
on which OS you run the admin; it should work.

Check your enUS/dsmclientV3.cat file and make sure it's modification time
matches that of the dsmadmc module.

If you continue to have trouble with this option, contact IBM technical
support.

Regards,

Andy

Andy Raibeck
IBM Software Group
Tivoli Storage Manager Client Development
Internal Notes e-mail: Andrew Raibeck/Tucson/IBM@IBMUS
Internet e-mail: storman AT us.ibm DOT com

The only dumb question is the one that goes unasked.
The command line is your friend.
"Good enough" is the enemy of excellence.

"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> wrote on 12/01/2004
02:29:55:

> Hi fellows,
> I have strange problem with administrative command line - dsmadmc.
>
> According to manual, from version 5.2 there is a new option
-dataonly=yes.
> This option is working on my Windows client (version 5.2.0.6), but not
on
> my AIX
> client. On my AIX 5.1 system, I have TSM server 5.2.2.5 and TSM client
> 5.2.3.0 (64bit).
> Following is output I get when I try to use dataonly option:
>
> root@neptun:/root/# dsmadmc -id=admin -pa=xxx -dataonly=yes q vol
> ANS8017E Command line parameter 3: 'dataonly=yes' is not valid.
>
> ANS8002I Highest return code was 9.
>
> According to manual, this option is supported on AIX. Any thoughts?
>
> Best regards
>
> Ing. Jozef Zatko
> Login a.s.
> Dlha 2, Stupava
> tel.: (421) (2) 60252618
ForwardSourceID:NT00054116