SV: Tsm not using drives
2003-09-05 10:30:18
Hi Gary!
I just back from a customer site where the drive was not in use.
TSM only use one of there two drives.
And Q Dr shows On-Line = Yes on both drives.
So type Q path f=d and see if the Path says On-Line also.
If not. Then Update the path and set online=yes.
Then it works fine again.
Good luck
Christian
-----Ursprungligt meddelande-----
Från: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]För Lee, Gary
D.
Skickat: den 5 september 2003 16:11
Till: ADSM-L AT VM.MARIST DOT EDU
Ämne: Tsm not using drives
Have a devclass 3590 with mountlimit=4. However, when doing migration, I never
see more than three drives in use. Even though I seem to have available
mountpoints, always there is at least one process waiting for mountpoint.
I do a "q mount" and never shows all four in use.
TSM v5.1.6.2 on solaris 2.8, library is 3494 with four 3590b drives.
All drives show on-line and available from "q dr".
Any ideas of where to start looking?
Gary Lee
Senior Operating Systems Analyst
Ball State University
phone 765-285-1310
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.515 / Virus Database: 313 - Release Date: 9/1/03
|
|
|