Re: Redirecting output on novell servers.
2000-11-16 08:49:40
The following used to work on Novell 4.x servers but went defunct in
Novell 5:
load dsmc query backup dir (CLIB_OPT)/>SYS:ADSM/ADSM.OUT
regards Walter Ridderhof.
______________________________ Reply Separator _________________________________
Subject: Redirecting output on novell servers.
Author: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> at INET-1
Date: 11/15/00 2:47 PM
Hello,
Except for the adsm schedule log I cannot find a way to save output
from the command line interface. I need the results of big restores
or big manual backups saved.
--
Mark Brown
Mark Brown
Operations Supervisor
=====================
Tel ---> 514-398-2321
Fax ---> 514-398-6876
E-mail ---> Mark.Brown AT mcgill DOT ca
-----------------------------------------------------------------
ATTENTION:
ATTENTION:
The information in this electronic mail message is private and
confidential, and only intended for the addressee. Should you
receive this message by mistake, you are hereby notified that
any disclosure, reproduction, distribution or use of this
message is strictly prohibited. Please inform the sender by
reply transmission and delete the message without copying or
opening it.
Messages and attachments are scanned for all viruses known.
If this message contains password-protected attachments, the
files have NOT been scanned for viruses by the ING mail domain.
Always scan attachments before opening them.
-----------------------------------------------------------------
=========================================================================
|
|
|