Hello All,

I have installed the Cisco Works integration tool into my NetView 7.1.3
Fixpak 1 environment and now need to created the TRAP definitions using the
good old mib2trap.  All sounded very simple as I have used this before for
other MIB files.

Unfortunately I get an "Open failed for
'STAND-ALONE-ETHERNET-SWITCH-MIB.my', stopping.". this happened on all the
MIB files installed by Cisco, any one seen this before or know of a way
around it?


Thanks in advance

Sean O'Connor
Tel:      (02380) 25 x7228
Mob:    (07887) 521169

****************************************************************************
B&Q plc
Registered Office: Portswood House, 1 Hampshire Corporate Park,
Chandlers Ford, Eastleigh, Hampshire, SO53 3YX
Buy Online NOW at http://www.diy.com

Registered in England Number 973387

This e-mail is only intended for the person(s) to whom it is addressed and
may contain confidential information. Unless stated to the contrary, any
opinions or comments are personal to the writer and do not represent the
official view of the company. If you have received this e-mail in error,
please notify us immediately by reply e-mail and then delete this message
from your system. Please do not copy it or use it for any purposes, or
disclose its contents to any other person. Thank you for your co-operation.
****************************************************************************