CISCO and possibly others allow an interface to have multiple IP
addresses all
except one being seconadry.  Problem is, NetView displays them as
different
submaps which is not what the real picture of the (physical) LAN is.  I
am
therefore looking for a way to graph submaps based on an IP interface
and
not on the subnet/mask pair.  Is this possible?

Best regards,

Yiannos Pitas

--

-----------------------------------------------------------------------------
Yiannos Pitas,                        |
Computer Center,                      |  Tel: 357-2-756186
University Of Cyprus,                 |  Fax: 357-2-756082
Kallipoleos 75,                       |  email: yiannos AT ucy.ac DOT cy
Nicosia,                              |  http://www.ucy.ac.cy/
CYPRUS.                               |
----------------------------------------------------------------------------