To the original poster, why not just tar up /opt/openv and put it 
somewhere before you upgrade?

--Steve


Donaldson, Mark wrote:

> ...One command to rule them all and in the darkness bind them...
>  
> Nope - sorry - you'll have to pull info from several commands.
>  
> Let's see:
>  
> Classes/Policies:
> "bppllist -U -allclients" or "bppllist -allclients"
>  
> Storage Units:
> bpstulist -U
>  
> Tape config:
> tpconfig -dl
>  
> General NB config:
> bpconfig -U
>  
> Anybody else?  Bueller? Bueller?
>  
>  
>
>     -----Original Message-----
>     *From:* Scott Jacobson [mailto:SJACOBSO AT novell DOT com]
>     *Sent:* Friday, September 12, 2003 9:36 AM
>     *To:* Veritas-bu AT mailman.eng.auburn DOT edu
>     *Subject:* [Veritas-bu] One Command - Lists All ???
>
>     In preparation for a worst case (backup for the backup) scenario
>     prior to a 3.4 to 4.5 cut over, I'm looking a command(s) that
>     would list all configuration information about classes, clients,
>     media servers etc. in case of a complete rebuild from scratch is
>     needed.
>      
>     All suggestions are welcome?
>      
>     Thank you,
>      
>     Scott Jacobson
>     NetBackup Systems Administration
>     Data Retention and Storage Management
>     I. S. & T. Provo Operations
>     sjacobso AT novell DOT com <mailto:sjacobso AT novell DOT com>
>     Desk Direct:   801-861-7668
>     Toll Free:        800-453-1267 Ext. 1-7668
>     Cell:                801-560-6891
>     Novell, Inc., the leading provider of Net business solutions
>     www.novell.com <http://www.novell.com>
>


-- 
===================================

  Steven L. Sesar
  Senior Operating Systems Programmer/Analyst
  UNIX Application Services R10A
  The MITRE Corporation
  202 Burlington Road - KS101
  Bedford, MA 01730
  tel: (781) 271-7702
  fax: (781) 271-2600
  mobile: (617) 893-9635
  email: ssesar AT mitre DOT org
 
===================================