[Veritas-bu] More duplicate images questions
2002-03-06 16:35:56
Hello Liao...
Thanks.. actually this make sense...
thx
Mike
On Wed, 6 Mar 2002, Dongfang Liao wrote:
> But normally the retention level should be same on one tape unless you
> specify to allow multi-retention level in the same tape. So in this
> scenario, I think to change the retention level for the whole tape will be
> better.
>
> Just my 2 cents comments.
>
> -----------------------
> Thanks
> ldf
> ----- Original Message -----
> From: "Michael Suen" <suen AT cosmos.buffalo DOT edu>
> Cc: "Veritas-Bu (E-mail)" <veritas-bu AT mailman.eng.auburn DOT edu>
> Sent: Tuesday, March 05, 2002 11:06 PM
> Subject: [Veritas-bu] More duplicate images questions
>
>
> >
> > Hello EveryOne...
> >
> > I just have a few more Duplicate images questions...
> > Is that possible to change the retension on the second copy of the
> > image.... NOT the whole media.
> > The bpexpdate -recalculate doesn't have a -copy option.
> > I would like to be able to change the second copy of a specific
> > backup image...
> >
> > Thanks
> >
> > Is that possible to list/find out where is the first and second
> > copy of my image? I was able to dup an image from disk to tape
> > but I was only able to see that specific image, copy number 2
> > with the Media ID of the "copy". Is that possible to list
> > the location (Media id) of the primary and copy...
> >
> >
> > Thank you very much for everybody's help..
> >
> > thx
> >
> > mike
> >
> >
> > _______________________________________________
> > Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
>
|
|
|