Hi

Can you not remove all but one device from the groups configuration?  (Or 
remove group from all but one device, remove this pool from all but one 
device). Used to do this quite a lot on 7.2 iirc. 
Sent via mobile.

-----Original Message-----
From: "STANLEY R. HORWITZ" <stan AT TEMPLE DOT EDU>
Sender: EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
Date:         Wed, 1 Jun 2011 09:01:56 
To: <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
Reply-To: EMC NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>,
        "STANLEY R. HORWITZ" <stan AT TEMPLE DOT EDU>
Subject: [Networker] Limiting a client to one of two tape drives

Greetings everyone,

I have one Linux client with four TB worth of data spread over four mount
points. This client is in its own savegroup, which has a tape pool devoted
exclusively to it. I want its backup to be limited to only one of the two
tape drives in my tape library. I have been playing around with different
settings, but every time I try it, the backup mounts two tapes even though
each drive has 16 as its target sessions value. This is with NetWorker 7.6
SP1 on a Linux box.

If anyone has any ideas on how I can do this without setting a pool target
limit of 1, please let me know.

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER