Re: [Networker] Command line recover fails to find volume
2006-07-28 13:13:51
Also I can do a directed recover from another client but only through
the nwadmin gui. Command line says it cannot find the volume. I am
using Networker 7.2.1
Thanks
Ben Harner wrote:
Hey All,
I recently added a new Solaris client and the backups run fine. But
if when I attempt to run the recover command line on the client it
fails to find the volume. Here is the errors I get.
07/28/06 10:52:40 ansrd: cannot look up save set for host foo and
savetime 1154051106
07/28/06 10:52:40 ansrd: vol_attr, err: aggr_rlists: bad return from
vol_info
07/28/06 10:52:40 ansrd: Cannot find the volume needed
Any ideas????
Thanks
Ben
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|