> After scanning the tapes they are always in state "write
> protected". Is this normal or is my procedure flawed?

I've only seen "write protected" as a reflection of the physical switch
on the tape.

The settings that Networker might use to avoid overwriting would be
"full" or "read only", which are different from "write protected".

-- 
Darren Dunham                                           ddunham AT taos DOT com
Senior Technical Consultant         TAOS            http://www.taos.com/
Got some Dr Pepper?                           San Francisco, CA bay area
         < This line left intentionally blank to confuse you. >

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=