[Networker] Using Pre-Labelled Tapes with single LTO Drive
2005-03-07 08:01:19
Hello List,
this is my configuration:
Several small and unconnected Networker Datazones. In every datazone is a NW
Server with a single tape drive. Media "management" (insert and remove tape)
will be done manually by persons on site with no NW specific knowledge.
Each NW site will be issued with a number of tapes that are already labelled.
Before the tapes can be used on site I use scanner to make the tape known to
the NW media database.
My question:
After scanning the tapes they are always in state "write protected". Is this
normal or is my procedure flawed?
Thank you,
Thomas.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listserv.temple DOT edu or visit the list's Web site at
http://listserv.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Using Pre-Labelled Tapes with single LTO Drive,
Staudenmaier, Thomas (IZLBW) <=
|
|
|