[Networker] Restore

Hi All,

Weird restore problem going on here w/ NW 6.1.3 running on Solaris 8.  I
normally do restores using ssid's so that I can get parallel restores going.

In the past I've done this:

recover -s nwsvr -S 1370830337 -S 1370919425 -S 1371983873 -S 1371984641

w/ very good results.  Now, I've got a high visibility production restore and
I'm getting:

NSR server `nwsvr': busy
recover: waiting 30 seconds then retrying

I've waited as much as 30 minutes w/o anything happening.

I've not only rebooted NW, but also the server and nothing else was happening
on the server at the time.  Same problem persisited.

In one instance, I pre-mounted a volume and a 'recover -s nwsvr -S 1370830337'
worked.  Then I did a 'recover -s nwsvr -S 1370919425' (next ssid) that I
verified existed on the same volume and I got the timeout stuff again.  Weird.

Other than disabling drives for the pool on a storage node (so that the SN
drives wouldn't be used), nothing that I'm aware of has changed on the box.

Any ideas?

Thanks,
        /\/elson

--
~~ ** ~~  If you didn't learn anything when you broke it the 1st ~~ ** ~~
                        time, then break it again.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=