"David E. Nelson" wrote:
>
> Hi All,
>
> We've got an L180, 6.1.3, and Solaris 8. All tapes are barcoded and the tape
> label == barcode. When we add tapes via the CAP, we have to do 'nsrjb -j
> L180-1 -IEv' to re-inventory the slot that were just filled. Is there any way
> around this so that NW can just use the barcodes and not have to physically
> load/unload each tape that was added via the CAP?
I was under impression that Networker loads the tape that is being
inventoried only in case if the barcode is not in the media database
yet. Are you saying all the tapes that you add were labeled before ?
>
> Thanks,
> /\/elson
>
> --
> ~~ ** ~~ If you didn't learn anything when you broke it the 1st ~~ ** ~~
> time, then break it again.
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|