Hi All,

We've got an L180, 6.1.3, and Solaris 8.  All tapes are barcoded and the tape
label == barcode.  When we add tapes via the CAP, we have to do 'nsrjb -j
L180-1 -IEv' to re-inventory the slot that were just filled.  Is there any way
around this so that NW can just use the barcodes and not have to physically
load/unload each tape that was added via the CAP?

Thanks,
        /\/elson

--
~~ ** ~~  If you didn't learn anything when you broke it the 1st ~~ ** ~~
                        time, then break it again.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=