Re: [Networker] st.conf problems
2002-11-08 08:31:08
ftp://ftp.legato.com/pub/HW_Support/compatguide/st.conf.supp.txt
#NOTE - there must be a semicolon after the last un-commented entry
# in the tape-config-list. If it is missing, st will not
# properly parse st.conf on startup, but will not make that
# fact obvious. Tapes will in general continue to work, but
# in a minimal functionality mode.
Alex Li
----- Original Message -----
From: "Vera Serra" <vera_serra AT BANRISUL.COM DOT BR>
To: <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>
Sent: Friday, November 08, 2002 8:54 PM
Subject: [Networker] st.conf problems
> Hi
>
> I have a problem to configure st.conf(Solaris 9/Networker 6.1.2) to
work
> fine with my DLT7000(Tandberg) and Tape-Array(clarriion/dds2). Is there
> anyone who can past me one example of st.conf having DLT7000 and DAT(dds2)
> configuration?
> My second question: Where is configurate the block size of my tapes?
> What is default to DLT7000(512KB?) and DDS2(32KB?)?
>
> I wait your answer as soon as possible
> thanks a lot
>
> Vera Serra
> Banrisul/Brasil
> email: vera_serra AT banrisul.com DOT br
>
> --
> Note: To sign off this list, send a "signoff" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|