Re: [Bacula-users] Jobs not showing in bconsole/BAT

Hi João,

Do you have job retention configured for your clients? If Bacula is not pruning your jobs because of pruning volumes, maybe you have a job retention period too short in your clients definition. Also your volume retention is 18 hours. If Bacula needs to recycle a volume early than 49 days it will do it and then prune all your job and files from catalog too. This is because Bacula applies the shortest retention period between these 3. If you want to keep your jobs, volumes and files for at least 49 days, I would recommend you to set all these three retention periods to 49 days.

Best regards,

Ana

On Thu, Jun 11, 2015 at 10:43 AM, João Kuchnier <joao.kuchnier AT gmail DOT com> wrote:

Hi everyone!

I'm working with bacula 5.2.13 on my network. Everything is doing fine. I have an autoloader with 7 tapes. Each tape runs 1 week. With this configuration I would have 49 days backed up in my LTO-4 tapes.

However, the comand list jobs only shows jobs from the last 28 days. In this moment I have jobs from day 2015-05-14 to 2015-06-11.

Is this write? Where are the other jobs?

My pool configuration:

Pool {
Name = xyz-tape-vol
Pool Type = Backup
AutoPrune = yes
Recycle = yes
Volume Use Duration = 7 days
Volume Retention = 18h
File Retention = 1 year
Job Retention = 1 year
}

Best regards!

João Kuchnier

------------------------------------------------------------------------------

_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users

------------------------------------------------------------------------------

_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users