hmmmm,
thanks for the hint :-)
At the moment both jobs are using one pool (differential pool). I allready 
searched in the archive but haven't found the solution. That's why I wrote the 
mail ;-)
Maybe i missed someting...... I will search again.

Thanks,
Stefan

________________________________________
Von: John Drescher [drescherjm AT gmail DOT com]
Gesendet: Freitag, 3. September 2010 18:17
An: Stefan Lubitz; bacula-users
Betreff: Re: [Bacula-users] Using multiple Drives / Bacula Version 2.4.4

> I am using a Tape library with two drives. Both are set up in the sd.conf.
>
> What can I do to run Backupjobs on both drives at the same time?
>
> At the Moment only one drive (/dev/nst0) is used.
>
> I am using Bacula 2.4.4.

If the jobs go to different pools then bacula should automatically
choose the empty drive. If two jobs that you want to run at the same
time go to the same pool the problem is getting bacula to load more
than 1 volume from a pool at the same time. There are ways to do this.
Please search the archives if no one else answers, I do not have to
time to look that up at the moment.

John
------------------------------------------------------------------------------
This SF.net Dev2Dev email is sponsored by:

Show off your parallel programming skills.
Enter the Intel(R) Threading Challenge 2010.
http://p.sf.net/sfu/intel-thread-sfd
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users