On 8/6/2010 2:32 PM, Win Htin wrote:
> Hi folks,
>
> I am trying to setup a new IBM TS3200 library running on CentOS 5.5 64
> bit. The Bacula version is 5.0.2 and the tape drives are LTO4s. I have
> successfully setup a couple of other exact type libraries in the past
> and had no issues albeit running older Bacula 2.4.X version. I went
> through exact same steps I have kept as my documentation and it is
> stumping me at the last stage where I cannot label the new tapes. I
> noticed in the older version mtx-changer did not read mtx-changer.conf
> file. I tried to compare the two and adjusted as necessary but still
> no go. Any ideas? TIA.
>
> ## Error message from bconsole:
> *label barcodes Storage=TS3200_1_DRV1 Pool=Scratch Slots=1
> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ...
> 3306 Issuing autochanger "slots" command.
> Device "LTO4_1" has 47 slots.
> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ...
> 3306 Issuing autochanger "list" command.
> The following Volumes will be labeled:
> Slot  Volume
> ==============
>     1  000001
> Do you want to label these Volumes? (yes|no): yes
> Connecting to Storage daemon TS3200_1_DRV1 at baculaserver:9103 ...
> Sending label command for Volume "000001" Slot 1 ...
> 3301 Issuing autochanger "loaded? drive 0" command.
> 3302 Autochanger "loaded? drive 0", result: nothing loaded.
> 3304 Issuing autochanger "load slot 1, drive 0" command.
> 3992 Bad autochanger "load slot 1, drive 0": ERR=Child died from
> signal 15: Termination.
> Results=Program killed by Bacula (timeout)
>
> Label command failed for Volume 000001.
>
>
> ## mtx.log shows:
> 20100806-14:14:30 Parms: /dev/sg22 loaded 1 /dev/nst0 0
> 20100806-14:14:30 Doing mtx -f /dev/sg22 0 -- to find what is loaded
> 20100806-14:14:30 Parms: /dev/sg22 load 1 /dev/nst0 0
> 20100806-14:14:30 Doing mtx -f /dev/sg22 load 1 0
> 20100806-14:15:16 The return value for load is 0
> 20100806-14:15:16 Device /dev/nst0 - not ready, retrying...
> 20100806-14:15:17 Device /dev/nst0 - not ready, retrying...
> 20100806-14:15:18 Device /dev/nst0 - not ready, retrying...

mtx-changer is a starting point. Sometimes it requires customization.

See http://www.freebsddiary.org/tape-library.php for how I customized my 
copy.

-- 
Dan Langille - http://langille.org/

------------------------------------------------------------------------------
This SF.net email is sponsored by 

Make an app they can't live without
Enter the BlackBerry Developer Challenge
http://p.sf.net/sfu/RIM-dev2dev 
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users