2010/7/26 Jeremiah D. Jester <jjest AT u.washington DOT edu>:
> I’m getting a bunch of error messages stating a “Volume data error” when I
> run ‘label barcodes’. John Drescher advised me to rewind that tape and write
> and eof to clear the data. However, in this case I did notice that the last
> line of output states that it was the volume was created successfully.
> Interesting enough the volume does not appear when I issue a ‘status slots’.
> Any thoughts on this?
>
>
>
> Here is the full error message output for one of the volumes.
>
>
>
> Thanks,
>
> JJ
>
>
>
> Sending label command for Volume "KL0433" Slot 14 ...
>
> 3307 Issuing autochanger "unload slot 13, drive 1" command.
>
> 3304 Issuing autochanger "load slot 14, drive 1" command.
>
> 3305 Autochanger "load slot 14, drive 1", status is OK.
>
> block.c:275 Volume data error at 0:0! Wanted ID: "BB02", got "". Buffer
> discarded.
>
> 3000 OK label. VolBytes=64512 DVD=0 Volume="KL0433" Device="Drive2"
> (/dev/nst1)
>
> Catalog record for Volume "KL0433", Slot 14  successfully created.
>
>

Can you look in the log for the timing. Normally the time is listed by
each message. I want to see if the system is giving the load enough
time.

John

------------------------------------------------------------------------------
The Palm PDK Hot Apps Program offers developers who use the
Plug-In Development Kit to bring their C/C++ apps to Palm for a share 
of $1 Million in cash or HP Products. Visit us here for more details:
http://ad.doubleclick.net/clk;226879339;13503038;l?
http://clk.atdmt.com/CRS/go/247765532/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users