Dear Arno Lehmann,
In message <496A79C1.50901 AT its-lehmann DOT de> you wrote:
>
> > 11-Jan 00:07 mneme-sd JobId 15630: 3304 Issuing autochanger "load slot 5,>
> > drive 0" command.
> > 11-Jan 00:12 mneme-sd JobId 15630: Fatal error: 3992 Bad autochanger "loa>
> > d slot 5, drive 0": ERR=Child died from signal 15: Termination.
> > Results=Loading media from Storage Element 5 into drive 0...done
> > Program killed by Bacula watchdog (timeout)
>
> Looks like the mtx-changer script takes too long...
Not really... no longer than before.
How long is "too long"? Is this configurable?
> The autochanger might be stuck, or rather, mtx doesn't return but
> waits indefinitely.
No, I just happened to watch it happen. The tape loads normally, as
far as I can tell.
> Storage daemon configuration, Device Resource, "Maximum Changer Wait"
> directive (iirc, this takes seconds, without qualifier, as an
> argument, not something like "10min"!)
I see. OK, will twiddle that know.
Um.... has the default setting of this parameter been changed in 2.4.x
(compared to 2.2.x and older) ?
> Also, you might run the mtx-changer script with debug output to a file
> and observe what it does, and were it stops doing things.
AFAICT mtx-changer completes normally, but I will test this.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd AT denx DOT de
Vulcans never bluff.
-- Spock, "The Doomsday Machine", stardate 4202.1
------------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It is the best place to buy or sell services for
just about anything Open Source.
http://p.sf.net/sfu/Xq1LFB
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|