Mike,
Is there
a way to increase the debug reporting level to get more
clues?
Les' suggestions are a good way to see if it is a
problem on the source file system.
For BackupPC, first try to limit the backup to the
smallest case that shows the problem (by excluding files or
creating a simple test tree to back up).
Then set $Conf{XferLogLevel} to 9. You should get
a lot of output in the XferLOG file.
You then have several options, eg: (1) send the
XferLOG file to the list if it short, or to me if it is large
- first make sure it doesn't contain anything confidential
like file names, host names, IP addresses etc (2) try running
manually the tar command (that generates the archive) that is
shown in the top of the XferLOG file, and pipe the output to
"tar -tvf -". Does it run successfully? Do you see the full
path?
Craig