Re: debugging chg-scsi
2004-11-04 16:24:59
On Thu, 04 Nov 2004 20:37:13 +0100, Christoph Scheeder
<christoph.scheeder AT scheeder DOT de> wrote:
> Hi again,
> you need WRITE-permisions on the sg-device-nodes to issue commands to
> the devices, but your listing only shows read and execute permisions.
> mine look like
Okay - here's the deal. My /dev/sg* entries are symlins. They're
pointing as follows:
/dev/sg0 -> scsi/host0/bus0/target0/lun0/generic
/dev/sg1 -> scsi/host1/bus0/target1/lun0/generic
/dev/sg2 -> scsi/host1/bus0/target3/lun0/generic
The permissions on the symlinks are 555, but the permissions on the
targets are 660, which is correct.
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: debugging chg-scsi, (continued)
- Re: debugging chg-scsi, Christoph Scheeder
- Re: debugging chg-scsi,
Erik Anderson <=
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi, Christoph Scheeder
- Re: debugging chg-scsi, Frank Smith
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Eric Schnoebelen
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Stephen Carville
|
|
|