Hi, Jean-Louis,
on Donnerstag, 16. September 2004 at 13:28 you wrote to amanda-users:
JLM> Hi Andreas,
JLM> On Mon, Sep 13, 2004 at 08:01:18PM +0200, Andreas wrote:
>> > Normally you only run it on a new installation, or when you install
>> > a new type of drive. It would be nice if it did check for a label
>> > first and not happily clobber some of your data without warning,
>> > especially since one of Amanda's advertised features is that it
>> > doesn't overwrite active tapes.
>>
>> Yes, it should IMHO spit out a warning or decline running until the user
>> specifies --force or something.
>> Also, it should be mentioned in the man page.
JLM> The latest amanda snapshot fix this.
Tested this, updated amtapetype-manpage and the tapetype-chapter in
the docs.
--
best regards,
Stefan
Stefan G. Weichinger
mailto:monitor AT oops.co DOT at
|