Martin Hepworth wrote:
got an exclude file setup which 'should' stop all but a single file
being backed up. But on first invocation its done ALL files. File is
below and debug stuff shows the file in the parameter list for tar.
...
this is amanda 2.4.2p2 (yes I know it old) on FreeBSD backing up a samba
share..
Amanda support for samba can handle only one exclude file.
(Samba 2.x.x and later could handle more, but nobody needed it
so badly that he patched amanda for it, yet.)
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|