RE: please help - autoloader problem !
2004-08-17 10:30:23
> -----Original Message-----
> From: Ernest Byaruhanga [mailto:ernest AT afrinic DOT org]
> Sent: Wednesday, August 18, 2004 1:18 AM
> To: Postaremczak Bernd
> Cc: amanda-users AT amanda DOT org
> Subject: RE: please help - autoloader problem !
>
>
> hello,
>
> On Tue, 17 Aug 2004, Postaremczak Bernd wrote:
>
> > > amtape: could not reset changer: no slots available
> > > changerdev "/dev/nst0"
> >
> > That's your Problem. It must be something like "/dev/sg1".
> Try to use
> > the command
>
> yeah, actually, the system sees the changer as /dev/sg2 but
> that is what
> was in the amanda.conf before. Now amanda.conf has:
>
> changerdev "/dev/sg2"
Good. Your next Problem is this line:
> rawtapedev "/dev/nst0" # the raw device to be used (ftape
only)
There must be also a "/dev/sg1" line. This must be the SCSI-Device of your
tape, not your loader. /dev/sg2 may be wrong, because it is your loader.
Does "mtx -f /dev/sg2 status" work? Try it first before you try it with
amanda. Then try to load/unload tapes with mtx. And then try it with amanda.
Regards
Bernd
|
|
|