Re: amanda config question
2004-04-21 21:37:34
Yes, that's a signal that amanda user doesn't have the right privs...in
my case I had to make sure amanda was in the 'disk' group since that's
the group of the tape device.
-Fran
Doug Penny wrote:
Great... that seems to have worked. Now I am getting the following message:
amlabel: could not load slot "0": open: /dev/ch0: Permission denied
I think I just need to be sure that the operator is in the right group.
Thanks for your help.
Doug
Doug,
tapedev "/dev/nsa0" # the no-rewind tape device to be used
I'm not sure if this is your problem, but my amanda.conf's tapedev looks
like this:
tapedev "0" # the says to look at chg-scsi.conf config 0
Your setting above might be causing amanda to not look in chg-scsi for
settings. Just a quick guess.
-Fran
--
Fran Fabrizio
Senior Systems Analyst
Department of Computer and Information Sciences
University of Alabama at Birmingham
fran AT cis.uab DOT edu
www.cis.uab.edu
205.934.0653
--
Fran Fabrizio
Senior Systems Analyst
Department of Computer and Information Sciences
University of Alabama at Birmingham
fran AT cis.uab DOT edu
www.cis.uab.edu
205.934.0653
|
|
|