mtx on RH 7.1 with attached Seagate Sidewinder 200 AL
2004-04-11 23:54:16
Part of bringing up Amanda, working to get mtx configured correctly. Seeing
initial setup OK, but then unable to load a tape.
Here's the setup:
- PC 300GL server (266MHz PII), Adaptec 2940US
- RH 7.1 w/ mtx 1.2.18
must use "noattach" option and get the following
[mark@StorPORH1 mark]$ mtx -f /dev/sg0 noattach status
Storage Changer /dev/sg0:1 Drives, 4 Slots ( 0 Import/Export )
Data Transfer Element 0:Empty
Storage Element 1:Full
Storage Element 2:Full
Storage Element 3:Full
Storage Element 4:Full
[mark@StorPORH1 mark]$
But can't get a tape to load:
[mark@StorPORH1 mark]$ mtx -f /dev/sg0 noattach load 1
mtx: Request Sense: Long Report=yes
mtx: Request Sense: Valid Residual=no
mtx: Request Sense: Error Code=70 (Current)
mtx: Request Sense: Sense Key=Illegal Request
mtx: Request Sense: FileMark=no
mtx: Request Sense: EOM=no
mtx: Request Sense: ILI=no
mtx: Request Sense: Additional Sense Code = 20
mtx: Request Sense: Additional Sense Qualifier = 00
mtx: Request Sense: Field in Error = 07
mtx: Request Sense: BPV=yes
mtx: Request Sense: Error in CDB=yes
mtx: Request Sense: SKSV=yes
mtx: Request Sense: Field Pointer = 00 00
MOVE MEDIUM from Element Address 2 to 1 Failed
[mark@StorPORH1 mark]$
Now should I see two LUNs in /proc/scsi/scsi ?
[mark@storporh1 mark]$ more /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 03 Lun: 00
Vendor: SEAGATE Model: AIT-LDR Rev: L1j4
Type: Sequential-Access ANSI SCSI revision: 02
[mark@storporh1 mark]$
Any ideas ?
Cheers de Mark @ 7tronics
Amanda-w4chl at sneakemail-dot-com
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- mtx on RH 7.1 with attached Seagate Sidewinder 200 AL,
Mark W4CHL <=
|
|
|