Re: amtape problems
2004-03-10 15:50:49
Hello Josh,
> Did you go through the tests in the chg-zd-mtx script? Those should
> confirm that your CHANGER.conf file is good.
(amanda)@atbackup:/usr/local/etc/amanda/atlab$ chg-zd-mtx -info
3 7 1
(amanda)@atbackup:/usr/local/etc/amanda/atlab$ chg-zd-mtx -reset
/usr/local/libexec/chg-zd-mtx: loadslot: not found
1
(amanda)@atbackup:/usr/local/etc/amanda/atlab$ chg-zd-mtx -slot next
/usr/local/libexec/chg-zd-mtx: loadslot: not found
4
(amanda)@atbackup:/usr/local/etc/amanda/atlab$ chg-zd-mtx -slot current
3 /dev/rmt/0hn
chg-scsi.conf
# $Date: 2004/03/10 20:39:13 $
# $Author: amanda $
# $Source: /usr/local/etc/amanda/atlab/RCS/chg-scsi.conf,v $
# $Revision: 1.2 $
firstslot=1 #### First storage slot (element) -- required
lastslot=7 #### Last storage slot (element) -- required
cleanslot=8 #### Slot with cleaner tape -- default is "-1"
driveslot=0 #### Drive slot number. Defaults to 0
autoclean=1 #### Set to '1' or greater to enable
autocleancount=20 #### Number of access before a clean.
havereader=0 #### If you have a barcode reader, set to 1
offline_before_unload=1 #### Does your robot require a 'mt offline' before
mtx unload?
poll_drive_ready=3 #### Time (seconds) between tests to see if the
tape drive has gone ready
max_drive_wait=120 #### Maximum time (seconds) to wait for the tape
drive to become ready
initial_poll_delay=3 #### initial delay after load before polling for
readiness
ugh, tests 2 and 3 fail - I could have sworn this was working the other
day....
Guess I need to find out why "loadslot" isn't found.
Thanks,
-Ben
|
|
|