Hi, anne,

on Montag, 24. März 2003 at 18:41 you wrote to amanda-users:

a> Hello

a> I finally installed amanda and everything is ok... except amrecover...

a> I saved a host whose name is carbone.edge-it.subnet. My amanda server is 
a> helium.edge-it.subnet. I can see an index :
a> /var/lib/amanda/edge/index/carbone.edge-it.subnet/_var_www/20030321_0.gz

a> But each time I want to try a recover it fails :

a> # amrecover edge
a> AMRECOVER Version 2.4.2p2. Contacting server on localhost ...
a> 220 helium AMANDA index server (2.4.2p2) ready.
a> 200 Access OK
a> Setting restore date to today (2003-03-24)
a> 200 Working date set to 2003-03-24.
a> 200 Config set to edge.
a> 501 No index records for host: helium. Invalid?
a> Trying helium.edge-it.subnet ...
a> 200 Dump host set to helium.edge-it.subnet.
a> Can't determine disk and mount point from $CWD

Use the same hostname as parameter for amrecover as you use in your
disklist.

As you can see up there it works out with "helium.edge-it.subnet"
instead of "edge". After that you have to tell amrecover which disk
you want to browse.

This disk is the DLE(disk list entry) you have in your disklist.

You seem to backup helium.edge-it.subnet:/var/www as far as I see so
you would have to enter:

setdisk /var/www

in amrecover if you called it with "amrecover helium.edge-it.subnet".

You could also just start up amrecover and then enter:

sethost helium.edge-it.subnet
setdisk /var/www

If you have indexing enabled in your dumptype for /var/www it should
work out fine.

-- 
best regards,
Stefan

Stefan G. Weichinger
mailto:monitor AT oops.co DOT at