On Tue, Jan 28, 2003 at 08:54:23AM -0500, Eric Sproul wrote:
> Hi all,
> After searching the archives, I can't seem to find an answer to a
> nagging little problem-- one of my clients is a Solaris 8 machine
> running software RAID, so its devices begin with "/dev/md/dsk...".
> However, AMANDA does not have this as one of her defined prefixes, so
> I'm forced to put the entire device name in my disklist, e.g.
> "/dev/md/dsk/d14" instead of just "d14" which would be nice and neat.
>
> I don't see a configure option where you can specify the device prefix.
> >From the debug output, I know the client at least has the ordinary
> "/dev/dsk" prefix. How do I add/change the device prefix in the
> client? I'm currently running 2.4.2p2 on the client, but I can upgrade
> if there is a way in the latest version.
You can set DEV_PREFIX and RDEV_PREFIX before configuration.
DEV_PREFIX=/dev/md/dsk/
RDEV_PREFIX=/dev/md/rdsk/
./configure ....
But then you will have to use the full pathname for disk in /dev/dsk
It could be possible to patch amanda to check in /dev/dsk and /dev/md/dsk
but you will not know if amanda backup /dev/dsk/d14 or /dev/md/dsk/d14
> As I said, this is really just a nuisance. The client is being backed
> up just fine. I just want my disklist to look nice! ;-P
It think it's nicer when you know what get dumped, that's why a prefer
to use full pathname in my disklist.
Jean-Louis
--
Jean-Louis Martineau email: martineau AT IRO.UMontreal DOT CA
Departement IRO, Universite de Montreal
C.P. 6128, Succ. CENTRE-VILLE Tel: (514) 343-6111 ext. 3529
Montreal, Canada, H3C 3J7 Fax: (514) 343-5834
|