Re: [ADSM-L] select and script
2008-08-26 10:30:07
I've been looking for a while on how to do this. It would open so many
possibilities, but I don't think it's possible at this point
Regards,
Shawn
________________________________________________
Shawn Drew
Internet
r.post AT PLCS DOT NL
Sent by: ADSM-L AT VM.MARIST DOT EDU
08/26/2008 09:45 AM
Please respond to
ADSM-L AT VM.MARIST DOT EDU
To
ADSM-L
cc
Subject
[ADSM-L] select and script
Hi all,
I'm convinced that it should be possible in TSM to do something like
the following in a TSM server script:
select into %1 pct_utilized from db
issue message I REMCO001 datbase for server is %1 percent full
But I can't anything anywhere on the web or the TSM manuals to point
me in the right direction. Am I mistaking, can't this be done? Or am I
not looking in the right places?
--
Met vriendelijke groeten/Kind regards,
Remco Post, PLCS
+31624821622
This message and any attachments (the "message") is intended solely for
the addressees and is confidential. If you receive this message in error,
please delete it and immediately notify the sender. Any use not in accord
with its purpose, any dissemination or disclosure, either whole or partial,
is prohibited except formal approval. The internet can not guarantee the
integrity of this message. BNP PARIBAS (and its subsidiaries) shall (will)
not therefore be liable for the message if modified. Please note that certain
functions and services for BNP Paribas may be performed by BNP Paribas RCC, Inc.
|
|
|