I've been testing NDMP backups using the datamover of an EMC Celerra
writing to a SAN attached 3494.

I needed to read between the lines in the docs a bit to figure out to set
it up, but its working.

But I don't see any info on how to setup a W2K B-A GUI so that it will read
the TOC(table of contents) and allow for DAR(direct access restore) of the
Celerra. (This seems to be how it needs to work, based on reading the
current "TSM Admin Guide (for AIX)".)

Do I need the "NAS" portion of the B-A client installed, even though the
system I have the W2K GUI on doesn't have access to the NAS portion of the
Celerra?

I've added a "nasnode" line to the dsm.opt, but the client still doesn't
show an entry for the Celerra in the GUI.

Any hints or pointers to pertinent docs appreciated.

Thanks, [RC]


==============================================================================
IMPORTANT NOTICE: This communication, including any attachment, contains 
information that may be confidential or privileged, and is intended solely for 
the entity or individual to whom it is addressed.  If you are not the intended 
recipient, you should delete this message and are hereby notified that any 
disclosure, copying, or distribution of this message is strictly prohibited.  
Nothing in this email, including any attachment, is intended to be a legally 
binding signature.
==============================================================================